Before starting the initial setup procedure and during the operation of the UTN server, please note the following safety regulations. The myUTN-800 is designed for the integration of USB dongles into TCP/IP networks. Safety Regulations UTN servers are network devices for use in office environments. No SD card is available in the card reader. The SD card is formatted with an unsupported file system respectively cannot be read and be written to. Which connection is not working is indicated by a glowing dot (left dot, left power supply right dot, right power supply). One of the two power supplies is not working. (Identifier) The Dongleserver is ready to operate. The connection to the respective port and the attached USB dongle is activated.ĭisplay panel The display panel on the front of the UTN server provides status information. No USB dongle is connected to the respective port.Ī USB dongle is connected to the respective port. Indicates the assignment of an IP address that does not correspond to 0.0.0.0 or that comes from outside the ZeroConf range. Indicates the assignment of a ZeroConfig IP address. If the activity LED blinks periodically at the same time, the BIOS mode is signalized. If the status LED blinks periodically at the same time, the BIOS mode is signalized. LED Display The LEDs of the UTN server provide information about its status. Ambient temperature: 5–40 ☌ - Relative humidity: 20–80 %Ĥ22 mm 44 mm 243 mm 2950 g with housing cover, without mounting brackets #Seh utn manager fullMax 1.3 A at 100–240 VAC (with full load on the USB ports) Network connection logical: physical: Device connection (This document)ģ) Activity LED (yellow) 4) Status LED (green) The Quick Installation Guide provides a brief description of the installation of the myUTN-800. Scope of Supply Please check the package content before getting started: The administration of the myUTN-800 is done via the 'myUTN Control Center'. The myUTN-800 itself can be mounted in a 19" server rack. The lockable housing cover on the Dongleserver allows for a central and safe storage of the USB dongles. The SEH UTN Manager shows the availability of all UTN servers in the network and establishes a connection between the client and the USB port including the connected USB dongle. The SEH UTN Manager is installed on all clients that are intended to access a USB dongle in the network. #Seh utn manager softwareThe software tool ’SEH UTN Manager’ handles the access to the USB dongles. The USB dongles will be connected to the USB ports of the myUTN-800. General Information Purpose The Dongleserver 'myUTN-800' gives network participants access to USB dongles. 13 Connecting the USB Dongle to the Client.14Ģ Configuring the UTN Server. 12 Adding the UTN Server to the Selection List. 11 Assigning an IP Address to the UTN Server. #Seh utn manager serial numberThe serial number can be found on the type plate.Ģ General Information. (CET)ĭate of Manufacture The serial number includes the date of manufacture. Falls Sie noch Fragen haben, kontaktieren Sie unsere Support-Hotline.Ĩ:00 a.m. Should you have any further questions, please contact our support hotline.īeachten Sie das Inhaltsverzeichnis auf Seite 21. Please note the table of contents on page 3. Sie erhalten die folgenden Informationen: It contains the following information:ĭieser Quick Installation Guide beinhaltet eine Beschreibung der Installation des myUTN-800. This Quick Installation Guide provides a description of the installation of the myUTN-800. MyUTN-800 Quick Installation Guide Overview
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |